SIIG UltraATA 133 PCI Installation Guide download pdf (Page 8)

7. Remove the driver CD. Restart Windows to

complete the driver installation.

To Verify Windows NT 4.0 Installation

1. Double click My Computer/Control Panel/SCSI

Adapters.

2. Highlight Silicon Image SiI 0680 ATA/133

Controller from SCSI Adapters listing and click

Properties. A message This device is working properly

is displayed in the dialog box, the driver has been

correctly installed.

Windows 2000

For New Windows 2000 Installation

A new installation of Windows 2000 requires a floppy

disk for the driver installation. To make this floppy disk,

copy the contents of the 32bit folder, found on the driver

CD, onto a blank floppy disk then follow the directions

below.

1. Install the board and follow Microsoft procedures

to install Windows 2000 accordingly.

2. Restart your system when prompted during

Windows' installation.

3. At the Windows 2000 Setup screen, press F6 to

install the driver.

4. Insert the driver diskette. Press S, then press Enter.

5. Select Silicon Image SiI 0680 ATA/133 Controller

and press Enter.

6. Press Enter to continue and follow on-screen

instructions to complete installation.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

No comments

SIIG UltraATA 133 PCI Installation Guide Page 8