SIIG UltraATA 133 PCI Installation Guide download pdf (Page 10)

For Existing 32-bit Windows XP/Server 2003 Installation

1. Install the board and boot up Windows.

2. At the Found New Hardware Wizard.

XP (w/SP1 or earlier)/Server 2003: continue to step #3

XP (w/SP2 or later)/Server 2003 (w/ SP1 or later): select

No, not at this time, then click Next.

3. Insert the driver CD, select Install the software

automatically (Recommended), then click Next

Note: Most systems will install the driver

automatically after inserting driver CD

4. Click Finish, remove the driver CD and restart

Windows to complete the installation.

64-bit Windows XP/Server 2003

For New Windows 64-bit XP/Server 2003 Installation

A new installation of Windows XP/Server 2003 requires

a floppy disk for the driver installation. To make this

floppy disk, copy the contents of the 64bit folder, found

on the driver CD, onto a blank floppy disk then follow the

directions below.

1. Install the board and follow Microsoft procedures

to install Windows accordingly.

2. Restart your system when prompted during

Windows' installation.

3. At the Windows Setup screen, press F6 to install the

driver.

4. Insert the driver diskette. Press S then press Enter.

5. Select Silicon Image SiI 0680 ATA/133 Controller

(64-bit Extended) and press Enter.

6. Press Enter to continue and follow on-screen

instructions to complete the installation.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

No comments

SIIG UltraATA 133 PCI Installation Guide Page 10