1Cyber 2S1P PCIQuick Installation Guide04-0345BIntroducing the Cyber 2S1P PCIThe Cyber 2S1P PCI high-speed serial I/O card providestwo 9-pin serial po
10Blank Page
11Technical Support and WarrantyQUESTIONS? SIIG’s Online Support has answers!Simply visit our website at www.siig.com and click on Support.Our online
Cyber 2S1P PCI is a trademark of SIIG, Inc.SIIG and SIIG logo are registered trademarks of SIIG, Inc. Microsoft and Windows areregistered trademarks
2Package Contents• Cyber 2S1P PCI board• Connector bracket w/9-pin serial port• Driver CD• Quick Installation GuideLayoutFigure 1. LayoutJumper Setti
3Serial Port 2 ConnectionFigure 2. Connecting the ribbon cableHardware InstallationGeneral instructions for installing the card are providedbelow, si
45. Change JP1-JP2 jumper settings to the desiredvoltage only if your serial device(s) needs additionalpower from the serial port. However, most ser
5Windows 98/98SE1. At the Add New Hardware Wizard, click Next.2. Select Search for the best driver for your device(Recommended), then click Next.3. In
6Windows NT 4.01. From the desktop click Start, then Run.2. Insert the driver CD, type inD:\NT4\Install_Serial.exe, then click OK. (ChangeD: to match
74. Insert the driver CD, type in D:\2000, then click OK.(Change D: to match your CD-ROM drive letter)5. Click Next and Finish.6. Repeat steps 1-5 two
84. Repeat steps 1-3 three more times.5. Restart Windows to complete the installation.To Verify Windows 2000/XP/Server 2003Installation1. Right click
92. Click Settings tab and click Advanced.3. Click the down arrow that is next to the COM Portnumber box and select a COM port that is not in use.Clic
Comments to this Manuals