SIIG USB Over IP User Manual download pdf (Page 10)

USB IP Admin Software Utility

2-1

Chapter 2

Hardware Installation and

Device Compatibility

2-1 Hardware Installation

General hardware installation instructions are provided

below. Since the design of computer cases and

motherboards vary, refer to your computer's reference

manual for further information, if needed.

Static Electricity Discharge may permanently damage

your system. Discharge any static electricity build up in

your body by touching your computer case for a few

seconds.

1. Connect one end of your Ethernet cable to the

Ethernet Port of the USB Over IP.

2. Connect the other end of the Ethernet cable to an

available RJ45 port on your Ethernet switch or hub.

3. Plug the power adapter into the USB Over IP, then

plug the power adapter into a reliable power source.

4. Wait for the USB Over IP to complete it's

initialization/bootup sequence and the Ready LED

to light up before proceeding to the next section.

2-2 Device Connection

The USB Over IP supports up to four USB devices.

Connect your USB device(s) to any port on the USB Over

IP. The green LED will light to show successful

connection.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 59 60

No comments

SIIG USB Over IP User Manual Page 10