SIIG RS-232 to Multi-Mode Fiber Optic Installation Guide download pdf (Page 4)

3-1 Software Installation

This section will guide you through the installation of the Microsoft

Windows software drivers.

Please refer to the appropriate "read.me" files on

the provided driver diskettes for installing other

network operating system drivers.

Windows 95

Perform the steps below to install the following Windows 95 driver

files:

Location of Driver: A:\WIN95 \DC1430.SYS

\NET143F.INF

\OEMSETUP.INF

1. When Windows 95 boots up after installing the card, a "New

Hardware Found" dialog box will appear and the "PCI Ethernet

Controller" will be identified.

2. At the "Add New Hardware Wizard" window, click "Next".

Then click "Other Locations".

3. Insert the Windows Driver Installation Diskette 1 in the floppy

drive.

4. Type a:\win95 in the location box. Click "OK", then

click "Finish".

5. From the "Insert Disk" window, click "OK". When the "Copying

Files" dialog box appears, type in a:\win95 and click "OK"

again.

6. When Windows prompts for the Windows 95 CD, insert the

Windows 95 CD into the CD-ROM drive. Type D:\setup and

click "OK". (Assuming "D" is the CD-ROM drive letter.)

7. Click on "Finish" and restart the system when prompted for the

driver to take effect.

Note: The FiberOptic Cards support 100Mbps speed only. You may

select 100 full-duplex or half-duplex mode configuration for

connection type. The default is 100 full-duplex mode.

An invalid connection type will not work in network connection.

1 2 3 4 5 6 7 8

No comments

SIIG RS-232 to Multi-Mode Fiber Optic Installation Guide Page 4