SIIG UltraATA 133 PCI Installation Guide download pdf (Page 2)

Package Contents

• UltraATA 133 PCI board

• Driver diskette

• 40-pin/80-wire Ultra ATA cable

• This quick installation guide

• One 5-year warranty card

Hardware Installation

General instructions for installing the card are provided below. If

needed, please refer to your computer’s reference manual for more

information.

Caution: Static Electricity Discharge may permanently damage

your system. To avoid possible static electricity discharge during

installation, please follow the guidelines below:

• Discharge any static electricity build up in your body by touching

a large grounded metal surface or the computer’s case (if

plugged in), for a few seconds.

• During installation, avoid any contact with internal parts.

Handle cards only by their external edges.

1. Turn OFF the power to your computer and any other con-

nected peripheral devices.

2. Unplug the power cord from the back of the computer.

3. Open your computer’s cover.

4. Remove the slot bracket from an available PCI slot.

5. To install the card, carefully align the card's bus connector with

the selected PCI slot on the motherboard. Push the board down

firmly, but gently, until it is well seated.

6. Replace the slot bracket's holding screw to secure the card.

7. Close your computer's cover and reconnect the power cord.

Note: Hold the board by its external edges only. Try to avoid

touching the components, connectors or pins.

1 2 3 4 5 6 7 8 9 10

No comments

SIIG UltraATA 133 PCI Installation Guide Page 2