SIIG JU-2NG012 Installation Guide

1USB 2.0+FireWire+10/100/1000Quick Installation Guide04-0310AFeatures and Benefits• Combo card design adds USB 2.0 (480 Mbps),FireWire (400 Mbps), Gig

102-5.2) Windows 2000 (with sp3 or later)/XP (withsp1 or later):a) Under the Universal Serial Bus Controllers:- NEC PCI to USB Open Host Controlle

11Technical SupportQUESTIONS? SIIG’s Online Support has the answers!Simply visit our Web site at www.siig.com and click onSupport. Our online suppor

USB 2.0+FireWire+10/100/1000 is a trademark of SIIG, Inc.SIIG and SIIG logo are registered trademarks of SIIG, Inc. Microsoft and Windows areregister

2Gigabit (10/100/1000 Mbps) Ethernet interface:• Fully compliant with IEEE 802.3, IEEE 802.3u, IEEE802.3ab• Supports Full Duplex Flow Control (IEEE 80

3FireWire (1394a)USB 2.0GigabitEthernetPower Connector(Optional)**LayoutFigure 1. Board Layout*NOTE: The Wake-On-LAN (WOL) feature is optionaland no

41) Hardware InstallationGeneral instructions for installing the card are providedbelow, since the design of computer cases andmotherboards vary. Refe

52) Software InstallationTo ensure proper installation of this board, please followthese instructions step-by-step.2-1) Windows 98SE Driver Installa

615. Choose Search for the best driver..., then click Next.16. Clear all boxes, then click Next.17. Choose The updated driver (Recommended), thenclick

79. Choose The updated software (Recommended)and click Next.10. Click Next, then Finish.11. Click Yes to restart Windows to complete.NOTE: If prompt

82-4) Windows XP Driver Installation1. Install the board, boot up your system, and insertthe driver CD.NOTE: If you have Windows XP with Service Pa

92-5) To verify successful driver installation:1. Check Device Manager to verify successful driverinstallation.Windows 98SE/ME: From the main deskto