SIIG JU-91RW12-S4 Installation Guide

1Introducing the Reader/Writer+FloppyThe Hi-Speed USB 9-in-1 Reader/Writer+Floppy easily addsfront-accessible multi-format memory card reader/writer a

10Blank Page

11Technical Support and WarrantyQUESTIONS? SIIG’s Online Support has answers! Simply visitour web site at www.siig.com and click Support. Our onlin

Hi-Speed USB 9-in-1 R/W + FDD is a trademark of SIIG, Inc. SIIG and the SIIG logo are registeredtrademarks of SIIG, Inc. Microsoft and Windows are

2System Requirements• Pentium or equivalent PC with an internal USBport (USB 2.0 recommended) and internal floppydrive controller• One available 3.5&q

3Figure 2. Rear Panel5.25" Mounting Rack AssemblyImportant: Use the Mounting Rack Assembly onlywhen installing the hub into a 5.25" drive b

44-Pin USB ConnectorFigure 5. USB Pin-out Header TableNote: See Figure 4, above, for proper orientationof the 4-pin USB Connector.+5VDC (Pin 1)Figur

5USB AdapterThis USB adapter is only needed if you plan to connectthe Reader/Writer+Floppy to a type-A USB port insteadof a USB pin-out header.Match u

65. Secure the Reader/Writer+Floppy to the drive bayby using the supplied mounting screws.Note: When installing the Reader/Writer+Floppyinto a 5.25&q

78. Connect the Reader/Writer+Floppy's 4-pin USBConnector to the system's internal USB port. Referto USB Pin-out Header, on page 4 for mo

8To Verify Successful Driver Installation1. Check Device Manager to verify successful driverinstallation.Windows ME: Right click My Computer, clickPro

9Accessing Memory CardsWhen the Reader/Writer+Floppy is successfully installed,two Removable Disk icons appear in My Computer.To access any one drive,